![]() carry out the lamp test t ascertain that each lamp lights up satisfactorily. Just the projector by referring to Section 13. Watching the test mode screen, make judgment the location building'sįrames and other game machines in the periphery. Although the projector adjustmentsīeen made at the time of shipment from the facĬolor deviation, etc., may occur due to the affeĬaused by geomagnetism. Lows the screen (on which the projector is tested) tĭisplayed. Not satisfactory, refer to Sections 9 & 10, Switch indicates "ON," the switch and wiring con ections are satisfactory,Īscertain the display of V. insert a coin from the coin inlet wi theĬoin chute door being open. Screen causes the screen (on which each switch and. ![]() Selecting the INPUT TEST on the test mode Game board is satisfactory if the display Adjust the position of Tie Bracket so that they lie flat against theįloor between the two Main Bases then fully tighen the retaining nuts.įig.3 Fitting the Wood Spacer to the Ca inetįig. M16 nuts can be used to lock the legs into position against the underside of the With the floor so that the casters clear the floor by approximately 5mm. Move the machine into position, screwout the 8 Leg Adjusters to make contact ~x M4 Flange nuts, to the back of the Coin Chute Tower. Before fitting Part B, make sure that the Earth wire isĬonnected to Ute Earth Stud on the back of the Coin Chute Tower using the It is recommended that excess length is loosly coiled upĪnd pushed against the connector panel on each main base.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |